![simplify 3d outline underspeed simplify 3d outline underspeed](https://docplayer.org/docs-images/46/19769793/images/page_8.jpg)
![simplify 3d outline underspeed simplify 3d outline underspeed](https://i1.wp.com/www.easy3dhome.com/wp-content/uploads/2019/09/image13.jpeg)
SIMPLIFY 3D OUTLINE UNDERSPEED SOFTWARE
The shell parts cannot be printed with the software that came with my printer. Simplify 3D will solve these small part problems so I will reprint them using this software. The maximum infill with the software that came with the printer is 90% and this results in some problems with fine details on the smaller parts. The results were best with layer thickness of 0.2mm.Īttempts to use 0.1mm layer thickness gave poor results. I used their excellent setting and maximum infill. I found the solid parts relatively easy to print with the software that came with the printer. I am printing the parts with a 0.4mm nozzle using white ABS for the solid parts and the vertical stab. Top solid layers =3 (instructions indicate 0 layers - I use 3 layers for additional bonding strength between parts - also I print Without a raft)īottom solid layers = 3 (instructions indicate 0 layers - I use 3 layers for additional bonding strength between parts - also I print Without a raft) This should be the first thing to adjust if you are experiencing a bad print.Įlmers Water washable "purple" glue stick is used on heated bed right before print starts, if put on early it is not as effective ( "Floreon Advanced" PLA was successfully tested, but I had more "Raptor" PLA on hand so I used that)Įxtruder temperature = 200 degrees C Many print problems occur because the extruder temperature is incorrect.
SIMPLIFY 3D OUTLINE UNDERSPEED SERIES
"Raptor" Series high strength PLA used for all other parts (This is very strong PLA, but gets excessively sticky at extrusion temperatures above 210 degrees C creating difficulty in printing small parts with fine detail) Crystal Series PLA for all Fuselage parts and tail boom mount Inexpensive filament with air pockets will certainly ruin parts with only one layer. The E3D BigBox printer I would not recommend. Most of the parts require very accurate printer control, and a bad slicer will make the print more difficult. Having a good slicer program will help with the printing of these parts. Simplif圓D is an excellent slicer program. This setup worked perfectly to accurately print all parts. E3D BigBox (I do not recommend this printer)